Leapfrog Support Team Document - http://support.lpfrg.com

| Applies To Leapfrog Creatr Series Single, Dual & XL:

| This solution instructs you how to resolve the failure to move to the "home position" before printing.

------------------------------------------------------------------------------------------------------------------------------------------------


1. Please watch the attached video to confirm your printers symptoms match this solution.


2. If your machine reacts like that when you press the X Home button inside the software, you will have to replace the X axis end micro switch and/or the wiring for it, in order to fix the problem.

The same applies to the Y direction, the carriage will move in small steps to the back of the machine when the Y Home command is pressed if the micro switch is defective and not working properly. 

As a temporary solution you can move the printing head by hand, all the way to the furthest front-left position, before the printing process starts.


3. Please open a support ticket and request a replacement end switch.

 

    

Component Photo Diagram For Reference: