In order to configure Repetier Host for your Leapfrog Creatr Dual 3D Printer we ask that you follow the steps presented below:

- This solution applies for the Leapfrog Creatr Dual and Creatr XL printers -

1. Open Repetier and go to the config menu and choose Printer Settings;

2. Next select the Printer menu and increase the number of extruders to two then press OK;

3. The last step is to check and make sure the configuration was a success; Go to the Manual Control section and check the Extruder option;

! Congratulations you are done and you can start printing !

Thank you for reading the solution and for any other issues please do not hesitate to contact our Leapfrog Support Team.


We wish you happy printing!