Hello and thank you for choosing the Leapfrog Creatr for your 3D printing needs.

This solution applies to the Creatr Single / Dual & Creatr XL;

In the following solution you will be instructed on how to adjust the Z offset of the bed in order to be able to calibrate the bed;

If you notice that the heated bed on your Creatr printer stops to far from the level of the hot ends or stops at different heights each time the bed moves towards the 0 position, thus calibrating the bed is not possible, please follow the steps below:

1. First make sure that the Z induction sensor is working:

2. Once the sensor is checked and you know for sure it works the next step is to make sure the distance between the sensor and bed frame is proper so that the bed stops in the same place each time:

3. In order to stop the bed closer to the level of the hot ends you need to move the plate on which the sensor is mounted on higher up the frame of the printer;

If you follow these steps you will be able to calibrate the bed more accurately and this in turn will result in good adherence to the heated bed of the printed models.

We thank you for checking out our Leapfrog 3D Printer technical support solutions online! If you were unable to fine a solution in our database, please feel free to open a new support ticket by clicking the following link: I want to open a new support ticket.