Leapfrog Support Team Document - http://support.lpfrg.com
| Applies To Leapfrog Creatr Series Single, Dual, HS, & XL:
| This solution explains how to correct printed output that appears shifted along X or Y axis.
------------------------------------------------------------------------------------------------------------------------------------------------
If your prints come out shifted or staggered along X axis direction or Y axis direction a possible solution is to tighten the black grub/set screws that hold the pulleys tight on the shaft that protrudes from the motors.
Follow the steps below to properly check if the grub/set screws are loose:
X direction(left-right)
1. Press X Home button inside the software.
2. Check for lost motion by pushing the printing carriage with your hand, like you see in the videos below:
Loosen the grub/set screws for the X motor
Tighten the grub/set screws for the X motor
Y direction(front-back)
1. Press Y Home button inside the software.
2. Check for lost motion by pushing on the X rails with your hand, like you can see in the videos below:
Loosen the grub/set screws for the Y motor
Tighten the grub/set screws for the Y motor
If you find that the grub/set screws need to be tightened you will need a 2 mm Allen key to do the job.
